EasyManuals Logo

Honeywell ADEMCO 6150 User Manual

Honeywell ADEMCO 6150
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
K3590-ADV2 4/04 Rev. A
ADEMCO 6150 & 6160
REMOTE KEYPADS
INSTALLATION AND SETUP GUIDE
Keypad Features
ADEMCO 6150
Fixed-Word
ADEMCO 6160
2-Line Alpha
Backlit Display YES (see note) YES (see note)
Dedicated Function Keys YES YES
Built-in Sounder Piezo Speaker
Note: Permanent display backlighting is an option on some controls (see the control's instructions for details).
GENERAL INFORMATION WIRING AND INSTALLATION
The ADEMCO 6150 and ADEMCO 6160 are addressable
Remote Keypads designed for use with ADEMCO control
panels. Addresses are set via the keypad keys.
The keys on the keypads are continuously backlit for
convenience.
KEYPAD DISPLAYS AND LEDS
The keypads have the following display features:
Model
Fixed
Word
Display
2-line
Alpha
Display
2-digit Zone
Identifier
Custom
Zone
Descriptors
6150 X X
6160 X X
The following table shows the LEDs and their functions:
LED Function
Red Lights when the system is armed in any mode
Green Lights when the system is "ready" to be armed.
SPECIAL FUNCTION KEYS
The keypads also feature function keys. These keys may be
programmed for panic alarms or other special functions such
as macros. See the control's instructions for details.
The keypads can be surface mounted directly to a drywall, or to
a single- or double-gang electrical box.
1. Remove the case back by pushing down two "snaps."
See diagram below.
2. Route wiring from the control panel through the
opening in the case back.
3. Mount the case back to a wall or electrical box.
4. Wire directly from the keypad’s terminal block to the
terminal block on the control board as follows:
Wiring Table (All Keypads)
Keypad Control Panel Wire Color
G Data In Green
– Aux Pwr (GND) Black
++ Aux. PwrRed
Y Data Out Yellow
See the control panel’s Installation and Setup Guide for
more complete details.
5. Reattach the keypad to its case back.
RETAINING
SNAPS
NOTE:
TO REMOVE CASE BACK
PUSH IN THE TWO MOUNTING
SNAPS LOCATED ALONG THE
BOTTOM OF THE KEYPAD
AND LIFT UP.
6150-006-V0
ARMED
READY
Function keys must be held down for at
least 2 seconds to activate an alarm, key
pairs activate immediately.
Function Keys
A or [1] and []
B or [] and [#]
C or [3] and [#]
D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell ADEMCO 6150 and is the answer not in the manual?

Honeywell ADEMCO 6150 Specifications

General IconGeneral
BrandHoneywell
ModelADEMCO 6150
CategoryKeypad
LanguageEnglish

Related product manuals