Set R slider tab
If you selected Option A in Step 5,
keep the slider tab in the R position
and insert your R or RC or RH wire
into the R terminal.
If you selected Option B in Step 5,
move the slider tab to the R & RC
position and insert your R wire into
the R terminal and RC into the RC
terminal.
Not to scale
Tip: Make sure at least 3/8” of the
wire is exposed.
Tip: You can use a needle-nose
pliers to push the wires gently into
the terminals all the way.
3/8”
Bundle and insert wires
through the wallplate
Gather your wires together and
guide them through the hole on
the back of the wallplate.
Do not remove the clear, rubber
wire holder.
Wall
Rubber
Wire Holder
To Next Page
Loading...
