Lyric
LyricLyric
Lyric
®
Controller
Supplement – Apple
®
HomeKit™
Programming
ProgrammingProgramming
Programming
the Lyric Controller
the Lyric Controllerthe Lyric Controller
the Lyric Controller
for using Apple’s HomeKit
for using Apple’s HomeKitfor using Apple’s HomeKit
for using Apple’s HomeKit
The Lyric Controller can be used with Apple’s HomeKit system for remote arming/disarming and
notifications of Lyric system events. You can also set up HomeKit’s Automation feature to respond to Lyric
events.
Lyric must first be paired with HomeKit, using an iPhone® or an iPad® running the Home
Home Home
Home app.
For more information on HomeKit, visit http://www.apple.com/ios/home/.
Requirements
RequirementsRequirements
Requirements
Apple devices
Apple devicesApple devices
Apple devices
• iPad & iPhone: iOS® 10 or later
• Apple TV®: tvOS™ 9.0 or later
Lyric Controller
Lyric ControllerLyric Controller
Lyric Controller
• The Controller’s software must be up-to-date.
• A full-time internet connection is required for Lyric software updates.
Pairing Lyric with an iOS device
Pairing Lyric with an iOS devicePairing Lyric with an iOS device
Pairing Lyric with an iOS device
Pairing requires an iPad or iPhone with iOS 10 or later and the Home
Home Home
Home app. The Lyric Controller appears to
HomeKit as an Accessory
AccessoryAccessory
Accessory.
• Your iOS device should be within a few feet of the Lyric Controller.
• The device’s Wi-Fi® must be turned on.
• The Lyric Controller’s Wi-Fi must be operating.
1. Launch the Home
Home Home
Home app. If prompted, turn on the device’s Wi-Fi and/or Bluetooth
and/or Bluetoothand/or Bluetooth
and/or Bluetooth.
2. The app identifies any available accessories. Select your Lyric system.
NOTE
NOTENOTE
NOTE: If your Lyric system is not identified, reboot the Lyric Controller and repeat this
process.
3. A keypad appears on the Lyric Controller’s touch screen. Enter the 4
44
4-
--
-digit
digit digit
digit Lyric
Master User code.
The 8
88
8-
--
-digit
digit digit
digit HomeKit setup code then appears on the Lyric touch screen.
4. On the iOS device, use the camera window in the app to capture the setup code. (If you wish, you
can enter the displayed code manually.) The device recognizes the Lyric Controller and the
Controller beeps 3 times.
If you need to confirm pairing, press Identify Accessory
Identify AccessoryIdentify Accessory
Identify Accessory on the app, and the Controller will beep 3
times.
5. Press Done
DoneDone
Done; Lyric appears in the app under Favorite Accessories
Favorite AccessoriesFavorite Accessories
Favorite Accessories and Lyric is ready to use with
Apple HomeKit.
NOTE
NOTENOTE
NOTE: If pairing fails, reset your HomeKit in the Controller: Security > Tools > [enter master
user code] > Advanced > Reset HomeKit
Reset HomeKitReset HomeKit
Reset HomeKit
and repeat the steps above.
When Lyric is paired with HomeKit, it is initially associated with HomeKit’s “Default Room”. You may want to
change this to reflect the location of the Lyric Controller. Typically, the Controller (seen below at far left) is
designated by the room where it is installed. Lyric’s sensors are also displayed as accessories.
To Next Page
Need help?
General
