Honeywell Notifier N16E - Expanding HS-NCM-W Network with HS-NCM-W-2

HS-NCM Installation Document — P/N 54014:C1 12/15/2020 13
6.3.2 Expanding an existing HS-NCM-W Network with the HS-NCM-W-2
When connecting the HS-NCM-W to a HS-NCM-W-2 you must use an RJ45 Ethernet cable. Refer to Figure 13, “Expanding an existing HS-NCM-W
network using the HS-NCM-W-2”
Programming for Expanding an existing HS-NCM-W network using the HS-NCM-W-2
Refer to Figure 13, “Expanding an existing HS-NCM-W network using the HS-NCM-W-2”
To establish a link, each board should be programed individually from its local panel as follows:
Board 1: Check “Ethernet Enabled” and set Port A Mode as “To Port A”
Board 2: Check “Ethernet Enabled”
Board 3: Check “Ethernet Enabled”
Board 4: Check “Ethernet Enabled” and set Port A Mode as “To BR Port A”
No other programming is required. Once programed, all nodes can be accessed remotely through VeriFire Tools.
HS-NCM-W
HS-NCM-W-2
A
B
BroadR-Reach
Legend
VDSL
Ethernet
Ethernet
VDSL
BroadR-Reach
HS-NCM-W-2HS-NCM-W-2
HS-NCM-W-2
A
A
A
A
A
A
A
A
A
B
B
B
BB B
B
B
B
HS-NCM-W
HS-NCM-W
HS-NCM-W
HS-NCM-W HS-NCM-W
RJ45
RJ45
RJ45
RJ45
Figure 13 Expanding an existing HS-NCM-W network using the HS-NCM-W-2
To next node
Port B
From previous
node Port A
X
X
X
X
From previous
node Port A
To next node
Port B
Board 1
Board 2
Board 3
Board 4