Honeywell QuietClean HFD-116 series User Manual

QuietClean OM.qxd 3/5/09
INSTRUCTIONS
READ AND SAVE THESE SAFETY
INSTRUCTIONS BEFORE USING
THIS AiR PURIFIER
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons, including the following:
1.
2.
10.
Read all instructions before operating the air
purifier.
Place air purifier where it ts not easily knocked
over by persons in the household.
Always turn the air purifier to the OFF position and
unplug from the wall outlet when not in use.
To disconnect the air purifier, press the Power
{c} button or turn the knob to the off position
{0) to turn the air purifier off, grip the plug and
pull it from the wall outlet. Never pull by the cord.
Do not use any product with a damaged cord or
plug or if product malfunctions, is dropped or
damaged in any manner. Keep the cord away
from heated surfaces.
Do not use air purifier outdoors.
Never use air purifier unless it is fully
assembled.
Do not run power cord under carpets, and do
not cover with throw rugs. Arrange cord such
that it will not be tripped over.
Do not use air purifier where combustible
gases, vapors or an oxygen rich environment
are present.
Do not expose the air purifier to rain, or use
near water, in a bathroom, laundry area or other
damp location.
Honeywell
QUIETCLEAN® AIR PURIFIERS
Models HHT-215, HHT-217, HHT-219 Series
Models HFD-010, HFD-015, HFD-110,
HFD-112, HFD-116 Series
11. The air purifier must be used in its upright
12,
13.
14.
15.
16.
17.
18.
19.
20.
N
—
position.
Do not allow foreign objects to enter ventilation
or exhaust opening as this may cause electric
shock or damage to the air purifier. Do not
block air outlets or intakes.
Locate air purifier near the outlet and avoid
using an extension cord.
This appliance has a polarized plug (one blade
is wider than the other). To reduce the risk of
shock, this plug is intended to fit only one way
in a polarized outtet. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician,
DO NOT attempt to defeat this safety feature.
A loose fit between the AC outlet (receptacle)
and plug may cause overheating and a
distortion of the plug. Contact a qualified
electrician to replace loose or worn ouilet.
Do not sit, stand or place heavy objects on the
air purifier.
Disconnect power supply before servicing.
WARNING: To Reduce the risk of fire or electric
shock, do not use this air purifier with any
solid-state speed control device.
The sealed UV bulbs contain a small amount of
mercury. Dispose of these items at household
hazardous waste collection sites only. If the UY
bulb breaks, do not vacuum or handle with your
bare hands, (HHT-215, HHT-217 or HHT-219 only.)
This product contains a built-in ionizer. While
the output of ozone of this product is extremely
low, if you have asthma symptoms or breathing
disorders that can be triggered by the presence
of an ionizer, we recommend that you do not
use any type of ionizing or ionic air purifiers.
Only HEPA filtration (non-ionizing} products
are recommended.
‘SAVE THESE
INSTRUCTIONS
The Honeywell trademark is used by Kaz, tac. under license from Honeywell International Inc.
+

Honeywell QuietClean HFD-116 series Specifications

General

Type	Air Cleaner
Model	HFD-116 Series
CADR (Smoke)	100
Speeds	3
Oscillation	No
Power Source	AC
Filter Type	Permanent, washable filter

Summary

Important Safety Instructions

Facts About Your Air Purifier

Introduction

Product Assembly

Setup Instructions

Operation for HHT-215, HHT-217, HHT-219 Models

Timer Operation

Program the air purifier to automatically turn off after a set amount of time.

Operation for HFD-010 Model

Operation for HFD-015, HFD-110, HFD-112, HFD-116 Models

Timer Operation

Program the air purifier to automatically turn off after a set amount of time.

Filter Clean Indicators

Resetting the Filter Clean Monitor

How to reset the filter clean monitor after cleaning the filter.

Filter Clean Indicator Operation

Explains when the filter clean indicator light indicates cleaning is needed.

Removing and Cleaning the IFD™ Micro-Filter

Cleaning the Washable Pre-Filter

Installing Odor-Lock™ Pre-Filters

Replacing UV Lamps

Installing the Filters

Cleaning and Maintenance

Frequently Asked Questions

Replacement Filters and UV Bulbs

Consumer Relations Information

5 Year Limited Warranty