Non-programmable Thermostat RTH111
11
*
Damage can occur if the compressor is restarted too soon after
shutdown. This feature forces the compressor to wait 5 minutes before
restarting. During the wait time, the message Cool On or Heat On
flashes on the screen. When the safe wait time has elapsed, the
message stops flashing and the compressor turns on.
System Setup (cont’d)
10.
Function
Default
setting
Options
1
Temperature display
format
0
0: Fahrenheit
1: Celsius
2
Heating cycles per
hour
5
2 to 6 cycles per hour
• 2: 30 min (steam, gravity)
• 3: 20 min (hot water, 90%+
high-efficiency furnace)
• 4: 15 min (gas or oil)
• 5: 12 min (gas or oil)
• 6: 10 min (electric)
3
Compressor
protection
*
1
0: Off
1: On
To Next Page
Loading...
