EasyManua.ls Logo

Honeywell RTH7500 User Manual

Honeywell RTH7500
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Question and Answer IconNeed help?

Do you have a question about the Honeywell RTH7500 and is the answer not in the manual?

Honeywell RTH7500 Specifications

General IconGeneral
Program Periods Per Day4
Wi-Fi ConnectivityNo
Hold FeatureYes
Filter Change AlertYes
Warranty1 year limited warranty
Temperature Range40°F to 90°F (4°C to 32°C)

Summary

Step 1. Prepare for Installation

Step 2. Follow Important Instructions

Do not connect the wires to the new thermostat based on wire color

Warning against using wire color for connections to avoid damage.

Step 4. Follow Special Instructions

Step 5. Label Old Thermostat Wires

Step 7. Connect Wires to New Wallplate

If wires are to be connected to both Rc and R, loosen the Rc and R screw terminals and remove the metal jumper wire

Instructions for removing the jumper wire when connecting both Rc and R terminals.

NOTES FOR CONVENTIONAL HEATING AND COOLING SYSTEMS

Important notes and cautions regarding conventional system wiring connections.

NOTES FOR HEAT PUMP SYSTEMS

Key notes and precautions specific to wiring heat pump systems.

Step 8. Install Batteries

Step 9. Attach New Thermostat to Wallplate

Step 11. Configure Installer Setup

Press the Up or Down arrows to select your setting for Installer Setup Number 0120

Instruction to adjust settings for Installer Setup Number 0120.

Set System Setting

Set Fan Setting

Program Your Heating and Cooling Schedule

Set Temperature Overrides

Understand Temperature Recovery Feature

Replace Batteries

Built-in Compressor Protection

Troubleshooting Tips

Related product manuals