To Next PageTo Next Page
Need help?Do you have a question about the Honeywell RTH7500 Series and is the answer not in the manual?
General| Programmable | 7-day programmable |
|---|---|
| Voltage | 24V |
| Wi-Fi | No |
| Temperature Range | 40°F to 90°F (4°C to 32°C) |
| Hold Feature | Yes |
| Filter Change Alert | Yes |
| Display | Backlit |
| Power Source | Battery |
| Accuracy | ±1°F |
| Weight | 181 g |
Ensures safety by disconnecting power and verifying the system is off.
Detach the old thermostat's faceplate and check for 120/240V wires.
Remove wires from the old wall plate, labeling each one for accurate connection.
Adjust the R-switch and insert the R-wire(s) into the appropriate terminals.
Connect wires to the UWP, install batteries, and attach the thermostat unit.
Restore power to the thermostat at the breaker box or switch.
Configure various system parameters like scheduling, temperature scale, and heating type.
Solutions for common problems like blank display, incorrect settings, or system response.
