Honeywell RWD21 User Manual

RWD21
INTRODUCTION
The Honeywell Water Leak Alarm is a
reusable spot detector that requires a
g:...volt battery. Place the Water Leak
Alarm in any potential flood spot- such
as next to washing machines, sinks, water
heaters, bathrooms, basements, boats,
sump pumps, garages. The alarm lets you
know when and if you have a leak.
OPERATING INSTRUCTIONS
1. On the bottom of the Water Leak
Alarm, use a coin to unscrew the battery
door, insert one 9V battery (not included)
and attach the battery leads to the
appropriate battery terminal.
Re-assemble the unit ensuring the a-ring
seal remains in place. The alarm is now
armed.
2. Place the Water Leak Alarm upright on
the floor or any area where a potential
water leak may occur within your home.
When both sensors on the bottom of the
Water Leak Alarm contact water, a loud
alarm sounds 3 times every 3 seconds as
long as water is present, for up to 24
hours. Do not place on a metal or other
conductive surface as the alarm may
sound without water present.
3. To disarm, remove the Water Leak
Alarm from the water or remove the
battery. Allow the device to completely
dry before re-use. It is also a good idea to
replace the battery at this time.
BATTERY REPLACEMENT
The alarm will chirp approximately once
every 30 seconds when the battery is
getting low. To change the battery simply
follow step 1 of the operating
instructions.
English
LIMITED 1 YEAR WARRANTY
1 year limited warranty from date of purchase, excluding
batteries.
Honeywell warrants this product, excluding battery, to be
free from defects in the form of workmanship or materials,
under normal use and service, for one (1) year from the date
of purchase by a consumer. If at any time during the
warranty period the product is determined to be defective or
malfunctions, Honeywell shall repair or replace it (at
Honeywell's option).
If the product is defective, (i) return it, with a bill of sale or
other dated proof of purchase, to the place from which you
purchased it; or (ii) call Honeywell Customer Care at
1-800-468-1502. Customer Care will make the
determination whether the product should be returned to
the following address: Honeywell Return Goods, Dock 4,
MN10-3860, 1885 Douglas Dr. N., Golden Valley, MN
55422, or whether a replacement product can be sent to
you.
This warranty shall not apply if it is shown by Honeywell that
the defect or malfunction was caused by damage which
occurred while the product was in the possession of a
consumer.
Honeywell's sole responsibility shall be to repair or replace
the product within the terms stated above. HONEYWELL
SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF
ANY KIND, INCLUDING AND INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR
INDIRECTLY, FROM ANY BREACH OF WARRANTY,
EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS
PRODUCT.
Some states do not allow the exclusion or limitation of
incidental or consequential damages, so this limitation may
not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY
HONEYWELL MAKES ON THIS PRODUCT. THE DURATION
OF ANY IMPLIED WARRANTIES INCLUDING THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE
ONE-YEAR DURATION OF THIS WARRANTY.
Some states do not allow limitations on how long an implied
warranty lasts, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may
have other rights which vary from state to state.
If you have any questions concerning this warranty, please
write Honeywell Customer Relations, 1985 Douglas Drive,
Golden Valley, MN 55422 or call1-800-468-1502.

Honeywell RWD21 Specifications

General

Brand	Honeywell
Model	RWD21
Category	Security System
Language	English