Need help?Do you have a question about the Honeywell X-618 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | X-618 |
| Category | Security System |
| Language | English |
Ensures compliance with local electrical safety regulations for product installation and use.
Guidelines for handling the appliance during transportation to prevent damage.
Specifies optimal operating environment conditions, including temperature and humidity.
Critical steps for safe operation, including proper installation and handling of power.
Guidance on understanding product labels and information within the manual.
Overview of the X-618 system and its main hardware products covered in the manual.
Identifies the target audience and lists reference documents for the X-618 system.
Provides essential guidelines and recommendations for using the X-618 system manual.
Instructions for powering the Digital Integrated System Manager (DCS) on and off.
Procedures for confirming system faults and restoring equipment state after repair.
How to activate and interpret the results of the DCS system's self-test function.
Selecting specific zones for broadcast and monitoring audio playback within zones.
Managing time delays for broadcasts and adjusting audio output volume levels.
Details on performing public address broadcasts, including selecting zones and sound sources.
Covers automatic and manual emergency broadcasting triggered by fire linkage signals.
How to monitor audio playback from speaker loops and adjust monitoring volume.
Instructions for powering the High Efficiency Power Amplifier (DA) on and off.
Important notices and warnings for safe and correct operation of the DA amplifier.
Understanding the meaning of indicator lights for power, fault, microphone, and network status.
Steps for initializing the X-NPMS and logging in to the system interface.
Overview of the function selection interface and the meaning of its icons.
Steps for selecting zones, groups, and tasks for manual broadcasting.
Detailed procedure for initiating and managing manual broadcasts in the NPMS.
How to broadcast audio content from USB files using the NPMS.
Creating and broadcasting synthesized speech content through the NPMS.
Procedures for recording audio and broadcasting recorded files via the NPMS.
Broadcasting audio files from an X-SMART specified list using the AOD feature.
Using the paging function and configuring one-click buttons for quick broadcasts.
Setting up scheduled or timed broadcasts for specific zones and tasks.
Selecting and adding specific zones for timed broadcast tasks.
Provides guidance on using the intercom feature for communication.
Interface for selecting target devices for initiating intercom calls.
Steps for making, receiving, and managing intercom calls between X-NPMS devices.
Monitoring audio playback from specific zones and viewing zone status.
Performing system operations like reset, acknowledgment, and lamp tests.
Adjusting volume levels for microphone, loudspeaker, line in/out, zones, and groups.
Viewing the status and fault conditions of all devices in a management group.
Accessing detailed information about a specific device, including IP, MAC, and firmware.
Viewing initiated tasks, deleting tasks, and stopping all tasks.
Configuring and using extension key modules (X-K8, X-K4) for system control.
Using the emergency button to activate automatic or manual emergency modes.
Instructions for operating the NRI and essential precautions for its use.
To Next Page
