To Next PageTo Next Page
Need help?Do you have a question about the Honeywell S1 and is the answer not in the manual?
Manufacturer not liable for damage caused by improper or inappropriate use.
Details CE marking, EU declaration of conformity, and ATEX certifications for hazardous areas.
Covers copyright, third-party contributions, and internet data transfer security.
Details manufacturer's liability limitations for product use and warranty conditions.
Defines operator responsibility for suitability and warranty voidance due to misuse or improper installation.
Specifies required specialist and technical knowledge for manual interpretation and use.
Defines the product's intended use with Elster/Honeywell gas meters and restrictions for other manufacturers.
Mentions metrological conformity assessment based on country-specific regulations.
Details environmentally friendly transport packaging and material recyclability.
Explains the opto-electronic scanning technology for identifying roller positions without contact.
Details the scanning process of digit rollers using light barriers and time-series analysis.
Describes mechanical versions S1/S1D and available communication protocols like NAMUR, SCR+, M-Bus.
Provides instructions for connecting the encoder, including cable type, pin assignment, and terminal usage.
Describes the top-mounted version for mechanical index drive and its connection.
General| Category | Media Converter |
|---|---|
| Humidity | 5% to 95% non-condensing |
| Model | S1 |
| Data Rate | 100 Mbps |
| Interface | RJ45 |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
