8
Charge the EDA61K
The EDA61K mobile computer ships with a partially charged
battery. Charge the battery with an EDA61K charging device for
a minimum of 5 hours. Using the computer while charging the
battery increases the time required to reach a full charge.
EDA61K mobile computers are designed for use with the
following EDA61K charging accessories: Home Base, Quad
charger and USB Cable. For information about accessories, see
the ScanPal EDA60K/EDA61K Series Enterprise Mobile
computer Accessories Guide” at www.honeywellaidc.com.
Turn Power On/Off
The first time you power on the computer, a Welcome screen
appears. You can either scan a configuration barcode or use the
Wizard to manually set up the computer. Once setup is
complete, the Welcome screen no longer appears on startup
and Provisioning mode (see page 13) is automatically turned off
(disabled).
To turn the computer on:
• Press and hold the Power button for approximately 3 seconds,
and then release.
We recommend the use of Honeywell accessories and
power adapters. Use of any non-Honeywell
accessories or power adapters may cause damage not
covered by the warranty.
Ensure all components are dry prior to mating the
computers and batteries with peripheral devices.
Mating wet components may cause damage not
covered by the warranty.
To Next Page
Loading...
