Honeywell ST9100A User Manual

6
PROGRAMMING YOUR ST9100A
The Built-in Programmes
The built-in programmes give you a starting point that you can personalise to your
own requirements. Your Installer should have selected one and ticked the box
alongside it. If there is no tick, the product normally leaves the factory with Profile A
installed, but it is a simple matter to select one of the other profiles (see Changing
the Installer Parameters, page 12).
Your Personal Programme
The table below has been left blank for you to record your own personal programme.
For ease of use, your ST9100A is supplied as standard with only 2 on/off’s enabled. To
enable ON/OFF period 3 see Fine Tuning your ST9100A (page 12).
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
Built-in Programme (Profile C)
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
6:30am 7:30am 5:00pm 10:00pm Not used Not used
Built-in Programme (Profile b)
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
6:30am 9:30am 4:30pm 11:00pm Not used Not used
Built-in Programme (Profile A)
ON 1 OFF 1 ON 2 OFF 2 ON 3 OFF 3
6:30am 8:30am 4:30pm 10:30pm Not used Not used

Honeywell ST9100A Specifications

General

Brand	Honeywell
Model	ST9100A
Category	Timer
Language	English