T775A/B/M SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLERS
31 62-0254—13
Fig. 74. Schedule - Options Menu.
3.2. OPTIONS
1. From the Schedule menu, use the and but-
tons to highlight OPTIONS.
2. Press the
button to display the Options menu.
Fig. 75. Schedule - Options - System Time.
3.2.1. SET TIME
Setting the system time is required to enable the
controller to follow daylight saving time.
IMPORTANT
Set the Date before setting the Time. See “3.2.2.
SET DATE”.
1. From the Options menu, use the
and but-
tons to highlight SET TIME.
2. Press the
button to display the current system
time setting.
3. Use the
button to cycle between the hour, min-
ute, and AM/PM values.
4. Use the
and buttons to increase/decrease
the desired value for the hour, minute, and AM/PM.
5. Press the
button to accept the Time and return
to the Options menu.
Fig. 76. Schedule - Options - System Date.
3.2.2. SET DATE
Setting the system date is required to enable the
controller to follow daylight saving time.
IMPORTANT
To properly account for Daylight Saving time, be
sure to set the Date before setting the Time.
1. From the Options menu, use the
and but-
tons to highlight SET DATE.
2. Press the
button to display the current system
date setting.
3. Use the
button to cycle between the month, day,
and year values.
4. Use the
and buttons to increase/decrease
the desired value for the month, day, and year.
5. Press the
button to accept the Date and return to
the Options menu.
MENU
To Next Page
Loading...
Need help?
General
