In heating, make sure the temperature setting is above the
room temperature and the flame _ is present in the display.
In cooling, make sure the temperature setting is below the
room temperature and a solid snowflake _,_ is present in the
display (T8775C only).
NOTE: If a call for cooling is made before the compressor has
been off for five minutes, or if a power interruption
occurs while the compressor is running, the thermostat
will go into a five-minute delay to protect the compres-
sor. The snowflake _,_ will flash during this delay.
Check the system fuse or circuit breaker and replace or reset if
necessary.
Check for air movement at the register.
If you have questions concerning this thermostat, call Honeywell
Customer Care at 1-800-468-1502.
69-1679ES--1 6
To Next Page
Loading...
Need help?
General
