Installation Guide
Wallplate installation
1. Separate wall plate from thermostat.
Grasp top and bottom
of
wallplate
and pull
to
remove from thennostat.
2.
Mount wall plate as shown below.
Drill 3/16" holes
for
drywall.
Drill
7/32" holes
for
plaster.
Must
be installed by a trained, experienced technician
• Read these instructions carefully. Failure
to
folloW these instructions
can damage the product
or
cause a hazardous condition
•.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock
or
equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury
in
a sealed tube,
do
not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
2
To Next Page
Loading...
