Honeywell VisionPRO TH8110U - Fan Setting

VisionPRO
®
TH8000 Series
7
Press &!. to select fan operation, then press
$/.%
• On: Fan is always on.
• Auto: Fan runs only when the heating or
cooling system is on.
• Circ: Fan runs randomly, about 35% of the
time, not counting any run time with the
heating or cooling system.
You can press &!. to override the fan settings
you’ve programmed for different time periods
(see page 11). If you select On or Circ, the
setting you select will remain active until you
press &!. again to select Auto (see page 27
for more information).
Press &!.
SCHED HOLD CLOCK SCREEN MORE
WED
AM
HEAT
Following
Schedule
Inside
Set To
70
6:01
70
FAN
AUTO
Fan setting
Note: If a fan schedule is programmed,
“Auto” will run the fan schedule.