Summary Screen will appear. Press * to continue or # to go back to make
changes.
At this time we will not enter Alpha Descriptors. We recommend using *82
for this. (Page 9-1 of the Installation and Setup Guide) Press “0”
You are ready to enter the next zone. Repeat step 9a for each zone.
NOTE: If you have any unused hardwired zones, these zones should be disabled
using Zone Type 00. Then enter 1 when asked to delete zone. We also
recommend adding a resistor to the zone as well.
When all zones are entered, press 00 at the screen where is asks you for a zone
number to exit.
Step 9b: Wireless Device Zone Programming (*56) (Page 5-1 and 5-7 of the
Installation and Setup Guide)
Enter *56
Set to Confirm will be displayed on the screen. This means: Are you
installing wireless devices? Press 1 = Yes
We will be using zones 9-48 (Wireless Transmitter Zones) for this step.
Enter the Zone Number you wish to program and press *. A summary
screen will be displayed. Press * again to advance past the summary
screen.
- Enter the Zone Type (ZT). (Refer above or go to page 5-2 in the
Installation and Setup Guide for the exact types). Press * to continue.
Enter the partition number (PT 1 or 2). (NOTE= Partition 3 is for common
areas between partitions 1 and 2). Then press *.
Report Code (RC) should be left at 01. The summary will show 10 though
this is correct. Press * to continue
Enter Input Type
o 2=Aux Wired
o 3=RF Supervised
o 4=UR Unsupervised
o 5=Button type RF transmitter
o Then press * to continue
You will trip the sensor you are entering. Upon activating the sensor, the
keypad will display the S/N of the device. Confirm that the S/N on the
keypad display and device S/N are both the same by entering “*”. If not hit
# and reenter.
Verify the screen is correct and hit * to continue.
At this time we will not enter Alpha Descriptors. We recommend using *82
for this. (Page 9-1 of the Installation and Setup Guide) Press “0”
You are ready to enter the next zone. Repeat step 9b for each zone.
To Next Page
Loading...
