Hardware Platform ZM5202
Device Type On/Off Power Switch
Network Operation Always On Slave
Firmware Version HW: 255 FW: 5.53
Z-Wave Version 6.81.03
Certification ID ZC10-19086694
Z-Wave Product Id 0x0039.0x4952.0x3135
Neutral Wire Required ok
Firmware Updatable Updatable by Manufacturer
Z-Wave Scene Type Central Scene
Security V2 S2_UNAUTHENTICATED ,S2_AUTHENTICATED
Frequency XXfrequency
Maximum transmission power XXantenna
Supported Command Classes
Application Status
Association Grp Info
Association V2
Basic V2
Central Scene V3
Configuration V4
Device Reset Locally
Firmware Update Md V4
Manufacturer Specific V2
Powerlevel
Scene Activation
Scene Actuator Conf
Security 2
Supervision
Switch Binary V2
Transport Service V2
Version V3
Zwaveplus Info V2
Controlled Command Classes
Basic V2
Explanation of Z-Wave specific terms
Controller — is a Z-Wave device with capabilities to manage the network. Controllers are typically Gateways,Remote Controls or battery operated wall
controllers.
Slave — is a Z-Wave device without capabilities to manage the network. Slaves can be sensors, actuators and even remote controls.
Primary Controller — is the central organizer of the network. It must be a controller. There can be only one primary controller in a Z-Wave network.
Inclusion — is the process of adding new Z-Wave devices into a network.
Exclusion — is the process of removing Z-Wave devices from the network.
Association — is a control relationship between a controlling device and a controlled device.
Wakeup Notification — is a special wireless message issued by a Z-Wave device to announces that is able to communicate.
Node Information Frame — is a special wireless message issued by a Z-Wave device to announce its capabilities and functions.
To Next Page
Loading...
