11
GENERAL DESCRIPTION
EN
IDENTIFICATION OF COMPONENTS
CONTROLS.........................................................FUNCTIONS
1. Transom plate
2. Motor mounting plate ........................................Reinforcement of the transom plate to which the outboard engine is attached
3. Manufacturer’s plate
4. Oarlock..................................................................Holds the oar in place while rowing
5. Oar ties..................................................................For storing the oars (power boating)
6. Oars .......................................................................Boat propulsion (x2)
7. Carrying handles
8. Hand hold .............................................................Enables passengers to hold on to the boat while boating (x8)
9. Deck.......................................................................Bottom of the boat (slatted PVC, inflated PVC or aluminum depending on the type)
10. Towing ring ..........................................................Towing attachment points (x2)
11. Mooring yoke......................................................Mooring line attachment point
12. Rope ......................................................................For mooring
13. PVC tube
14. Assist handle .......................................................Enables passengers to hold on to the boat while boating
15. Inflation/deflation valve
16. Bench ....................................................................Sit here to row
17. Drain plug ............................................................Water drain plug
18. Hoisting ring.........................................................Davit arm attachment points (x4)
19. Lifting handles (x2)
20.Fuel line holders
21. Bow roller.............................................................Used to hold the rope when anchored
IDENTIFICATION OF YOUR BOAT
a. Boat type
b. Boat length .........................................................................................................................(m)
c. Boat design category .......................................................................................................Europe Category 2013/53/EU
d. Maximum number of persons (Adults/Children)
e. Maximum load capacity (Equipment + Engine + Persons).....................................(kg)
f. Maximum engine power (engine).................................................................................(kw) (HP)
g. Maximum engine weight ................................................................................................(kg)
h. Recommended working pressure ...............................................................................Tube (bar) – Keel/Floor (bar)
i. Honda Serial Number
SUN SELECTIONS CO., LTD.
Weihai, Κίνα
Exclusively designed to
Boat type MX-250/0AL
Length m
Category C
Nos. of person /
Max. load capacity Kg
Max.Engine power hp
Max.Engine weight kg
Working pressure
Tube. 0.25 bar
Keel 0.35 bar
BUILT TO EN ISO 6185
(Honda VIN.) T25AE-
To Next Page
Loading...