7
Auto-Stop Reels
Manual Mode
Disconnect the reel from the power
source.
Lock the handle into gear.
Fight sh as desired.
Usage Recommendations
The full speed option should be used
to retrieve the bait with no sh, setting
the hook, or to keep up with a fast
rising sh. Half speed or less is
recommended, while ghting a sh.
The speed can be determined by the
individual ghting their sh.
Maintenance
Treat reel as any other high-end shing
equipment. Minimize exposure to
extreme salt spray, even though the
reel is sealed. Rinse reel after every
use with dish soap and clean water
and dry thoroughly. Wiping with water
repellent lubricants such as WD-40
®
,
CorrosionX
®
, or CRC
Heavy Duty
Silicone is recommended.
Auto-Stop Mode
The reel will not operate if the display
counter reads zero (0) or any negative
number (-).
Override Mode
The reel will operate regardless of the
count on the display.
While in the Auto-Stop
Mode, you’re retrieving
your weight at full speed, the counter
reaches zero (0), the reel stops. You
want to retrieve the remaining line.
Turn the variable speed control
knob counter-clock wise to the OFF
position.
Press the button to enable
override.
Turn the variable speed control
knob to the desired speed to retrieve
the remaining line. The display will
show a negative number. If you
choose to reset the counter to zero,
hold the button for ve seconds until
the display resets.
EXAMPLE
To Next Page
Loading...