Hoover 5007PH - Assembling the Vacuum Cleaner; Connecting the Hose and Tube

Warnings
7.
Assembling the Vacuum Cleaner
IMPORTANT! Always remove the plug from the power socket before fitting
or removing accessories.
1. Fitting or Removing the Flexible Hose
Fitting:
Insert the flexible hose into the air inlet of the vacuum. Press until it
clicks into position.
Removing:
Remove the plug from the power socket and then release the flexible
hose from the air inlet by depressing the two buttons.
b. Fit the floor head to the telescopic tube, gently insert the
telescopic tube into the floor head and push until it clicks
in place.
You will hear the click sound.
2. Fitting the Telescopic Tube
and Accessories
Important: Ensure the powerhead switch on the handle is
in the “off” position before fitting the handle to the tube.
a. Fit the telescopic tube to the handle, gently insert the handle
into the telescopic tube and push until it clicks in place.