PAUSING THE MACHINE
l Keep the START/PAUSE button pressed
for about 2 seconds (the name of the
programme and the residual time display
will flash, showing that the machine is
paused).
l Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l To cancel the programme, turn the
programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
l This button allows to delay the start of the
programme from 30 minutes (1 hour on
some models) to 24 hours in 30 minutes
intervals (1 hour on some models).The
delay selected is shown on the display.
l After pressing the START/PAUSE button
the time showed decrease minute after
minute.
l It's possible transform a cycle from
automatic to programmed, up to 3
minutes after the start of the cycle.
l The progressive pressure increases the
time in 10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
l In case of incompatibility, all indicator
lights flash quickly for 3 times.
l If the programme selector is positioned on
the rapid programmes, the progressive
pressure of the key allows you to choose
the cycle time between: 30-45-59 minutes.
This button allows you to store the options
set on a cycle.
MEMORY:
select the programme and the desired
options, then press the button MEMO for 3
seconds (before starting the cycle). The
writing MEMO (all the digit on some models)
will blink for 2 seconds and the options
connected to the cycle selected will be set.
RECALL:
after the selection of the cycle press the
button MEMO for recall the stored options
(not the cycle).
l This button allows to set the desired
dryness level editable option up to 3
minutes after the starting of the cycle:
To Next Page
Loading...
