What does E7 error mean on Hoover HBDO485TAMCE/1-S Washer/Dryer?
If your Hoover Washer/Dryer displays error code E7 or the LEDs flash seven times, make sure the door is correctly closed and that clothes inside the drum aren’t preventing it from closing fully. If the door is locked, turn off and unplug the washing machine, wait 2-3 minutes, and reopen the door.
How to fix E3 error on Hoover Washer/Dryer?
If your Hoover Washer/Dryer displays error code E3 or the LEDs flash three times, check that the filter is not clogged and that there are no foreign objects inside the filter compartment. Also, make sure the drain hose isn’t bent, kinked, or trapped, and ensure the home drainage system is not blocked.
What does E2 error mean on Hoover HBDO485TAMCE/1-S Washer/Dryer?
If your Hoover Washer/Dryer displays error code E2 or the LEDs flash twice, make sure the water supply tap is open, the water supply hose isn’t bent, kinked, or trapped, and the drain pipe is at the proper height. Clean the “anti-sand” filter and check the filter for clogs or foreign objects.
What to do if my Hoover HBDO485TAMCE/1-S Washer/Dryer does not spin?
If your Hoover Washer/Dryer isn't spinning, try removing and de-tangling the load, then reload and restart the spin program. Ensure that the 'no spin' function isn't selected and check the selected options' effect on the spin cycle. Also, using too much detergent can impede the spin cycle, so ensure you're using the correct amount. If the water hasn't completely drained, wait a few minutes; if the problem continues, see Error 3 section.
Why is my Hoover Washer/Dryer making noises during the spin cycle?
If your Hoover Washer/Dryer is vibrating or making noises during the spin cycle, make sure the appliance is fully leveled by adjusting the feet. Also, ensure that transport screws, rubber bungs, and spacer tubes were removed during installation. Finally, check the drum for any foreign objects like coins or buttons.
Why Hoover HBDO485TAMCE/1-S is not spinning?
If your Hoover Washer/Dryer isn't spinning, try removing and de-tangling the load, then reload and restart the spin program. Ensure that the 'no spin' function isn't selected and check the selected options' effect on the spin cycle. Excessive detergent can also impede spinning, so use the correct amount. If the water hasn't completely drained, wait a few minutes.
Why is there water leaked on the floor near my Hoover Washing machine?
If you see water leaked on the floor near your Hoover Washing machine, it could be due to a leak from the seal between the tap, supply hose, and fill valve; in this case, replace it and correctly tighten the hose connections. Also, make sure the front filter is correctly closed.
Why Hoover HBDO485TAMCE/1-S does not start?
If your Hoover Washer/Dryer isn't starting, ensure it's properly plugged into a working socket and that the power is on. Test the wall socket with another appliance. Also, check that the door is correctly closed, the program is correctly selected, the start button has been pressed, and that the machine isn't in pause or time delay mode.
How to fix Hoover Washer E2 error / 2 flashes?
General| Brand | Hoover |
|---|---|
| Model | HBDO485TAMCE/1-S |
| Category | Washer/Dryer |
| Language | English |
To Next Page