Why Hoover HVM6316M Washer/Dryer does not work on any programme?
Your Hoover Washer/Dryer might not be working because the plug is not in the socket, it is not switched on, there is a power failure, the fuse is blown, the door is open, or the RCD has tripped. To resolve this, plug the appliance in, switch it on, check the fuse, close the door, and reset the RCD. If there is a power failure, refer to the 'Power Failure' section.
What to do if water does not drain away from Hoover HVM6316M?
If the water is not draining from your Hoover Washer/Dryer, it could be due to a kink in the discharge hose, foreign bodies in the filter, or incorrect plumbing. Straighten the discharge hose, examine the filter for obstructions, and check the plumbing installation.
What to do if my Hoover HVM6316M Washer/Dryer does not fill with water?
If your Hoover Washer/Dryer is not filling with water, check if the plug is in the socket and the appliance is switched on. Also, the water supply might be turned off, or the programme selector might not be correctly positioned. Turn on the water supply and ensure the programme selector is in the correct position.
Why Hoover HVM6316M does not spin?
Your Hoover Washer/Dryer might not be spinning because the water has not yet drained away, the 'Spin Cancel' option has been selected, or the load is unbalanced. Wait a few minutes for the machine to empty, check if the 'Spin Cancel' option is selected, and rearrange the load evenly.
What to do if my Hoover HVM6316M machine vibrates a lot during spin?
If your Hoover Washer/Dryer vibrates excessively during the spin cycle, it could be due to the machine not being level, an unevenly distributed load, or the transit brackets not being removed. Adjust the feet to level the machine, rearrange the laundry for even distribution, and remove the transit brackets.
What to do if there's water on the floor around my Hoover washing machine?
If you find water on the floor around your Hoover washing machine, it could be due to a leaking gasket between the tap and water inlet hose, a strand of clothing or dirt between the door rubber gasket and door glass, or incorrect plumbing. Replace the gasket and tighten the connection, reload the machine and keep the rubber door gasket/door glass clean, and check the plumbing.
General| Brand | Hoover |
|---|---|
| Model | HVM6316M |
| Category | Washer/Dryer |
| Language | English |
To Next Page