OPERATION
OPERATION
4
3
To use the blower
function, insert end of
hose into blower function
on top of bin lid and
press ‘On’ button.
How to use the blower function
Insert end of hose into vacuum cleaner inlet on main body.
Connect the metal extension tube and the hose handle together. All accessories can be fitted onto
extension tube. Connect the extension tube into the combination floor head. Ensure all parts are firmly
attached before use.
Important: Install the filter cover for using in dry mode, and take it out when sucking up water.
Assembling your vacuum cleaner
Insert power plug into mains socket. Turn on.
Turn vacuum cleaner on/off by pressing power switch on top of lid.
Important: Never use this vacuum cleaner with any of the filters removed as this could cause damage
to the internal components and void your warranty.
Important: Before using the vacuum cleaner in dry mode, ensure the foam filter and the filter cover
are installed.
Turn the machine on and off
Insert the hose to the
hose connector and
turn anti-clockwise
until fixed.
Vacuum cleaner
can be used with or
without a dust bag.
If you would like to
use a dust bag, attach
the bag to the tube
inside the dust bin.
How to use in dry mode
Control the suction
by adjusting the
air flow button
on the handgrip.
For use on carpet
click rocker switch
forward. For use on
hard floor click rocker
switch back.
How to use in wet mode
Unclip bin lid using
clips attached to side
of unit.
Remove bin lid. Remove filter cover. Remove the dust bag
if present.
Attach squeegee tool
and turn the machine on.
To Next Page
Loading...
Need help?
General
