CHANGING THE BELT OR BRUSHES CLEARING A BLOCKAGE
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
!
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
!
If your cleaner is not picking up efciently, the belt or brushes (or both) may need replacing, but rst please make
sure you have:
• Emptied the dust container
• Cleaned the lters
• Checked for blockages
Turn the cleaner over and
remove 6 retaining screws
attaching the brush guard
to the base.
Remove the brush guard
Remove brush assembly and
check for wear on the belt.
Loop the new belt around
the motor and brush
channel.
Hold the brush assembly and
stretch the belt until the brush
can be slotted back into
the cleaner housing.
Rotate the brush to ensure
movement of the belt.
Refit the brush guard with 6
retaining screws.
1 4
2
3
5
6
If cleaning tools were
in use check the clean-
ing tool and the remov-
able handle.
Check the hose by
removing it from the
cleaner, stretching it to
full length .
Turn the cleaner
over and rotate the
brushes until they
are free to rotate.
Check for a blockage in
the hose socket. Use a
flexible rod to remove
any obstruction.
Open the pet hair and
allergen remover at
each side, lift cover
and remove the block-
age.
- 7 -
To Next Page
Loading...
