7
CHANGING THE DUST BAG
The cleaner should be switched off and disconnected from the mains supply before you
start to assemble.
1. Disconnect cleaner from power and remove hose from inlet duct.
2. To gain access to the dust-bag, lift the catch located under the inlet hole and raise the
top cover.
3. Without touching the dust-bag, lift the bag assembly and remove.
This will allow you to remove the bag from the holder.
4. To remove dust-bag, push the bag retaining clip and separate bag from holder.
Fitting a new bag is a reversal of above. The arrows on the bag collar show correct
positioning.
5. Replace completed assembly back into cleaner. The top cover will not close nor will
the cleaner operate without a dust-bag fi tted.
FILTER REPLACEMENT
Your cleaner is fi tted with 2 fi lters for cleaner air. Dirty fi lters will restrict motor
performance and cleaning effi ciency. Never operate without fi lters fi tted. The motor fi lter
is located directly behind the dust-bag assembly.
Bag out and motor
fi lter removed.
Replacing motor fi lter HEPA Filter
To Next Page
Loading...
