Hoover IronSpeed - Page 7

6
6
Chapter 3: Using Your Steam Generator
Select the temperature of the soleplate by turning the dial (6) on the iron to the desired posion.
Wait a few moments unl the temperature indicator (8) is o.
It will indicate to you that the soleplate has reached the requested temperature.
While ironing, the temperature dial indicator may turn on and o, the temperature
adjusts without interrupng your ironing.
Help
To know the best suitable temperature for each texle, check the laundry care label
of the arcle to be ironed. Please note that during use, the temperature light goes on
from me to me. It signies that the iron is heang up to the set temperature.
If a fabric is made with various kinds of bres always select the soleplate temperature
in adequacy with the most delicate one.
If you select a lower temperature while ironing, wait unl the iron has cooled down to
the set temperature before you connue ironing.
If the temperature is too low, some drops of water could escape from the soleplate.
Please raise up the temperature above the 2 dots (••) to avoid this issue.
Connect the appliance with the mains cord to an earthed socket and switch on the
power. Press the on/o switch. The light (1A) will illuminate, this tells you that the
appliance is working and that the boiler is heang up.
Aer approximately 2 minutes, the “steam ready” led will light o and you can now
start to use the steam feature.
N.B.
The rst me the appliance is used, you may nd some fumes, dust and a smell
should appear.
It’s quite normal and will quickly disappear.
This is due to a treatment applied to the soleplate that improves the steam performance.
Before use, please use the iron as described in Chapter 3.4 Vercal Steam Ironing.
Chapter 2.3 - Switching on the Appliance
Chapter 3.2 - Ironing
Dry Ironing
Select the temperature of the soleplate following the indicaons of chapter 3.1. Start
your ironing without pressing the steam trigger (7), when the soleplate reaches the
appropriate temperature.
Steam Ironing
Select the temperature of the soleplate following the indicaons of chapter 3.1. The
steam will be ready to be used aer 8 minutes and the dedicated lamp(1C) will turn
o..Starng from that me you can begin your ironing and press the steam trigger (7)
for having steam. The steam ow stops when you release the trigger.
N.B.
During use, you may hear noise coming from your steam generator. This is normal. It
signies that a pump is injecng water into the boiler. Ideally, avoid using the steam
trigger at this precise moment to avoid a fall in pressure.
Chapter 3.1: Regulang the Soleplate Temperature