8
OPERATION
8
Press the brushbar on/off button to
switch the brushbar on.
Press the boost button on to increase
the suction for particularly dirty areas.
Press the on/off button to switch the
machine on.
CAUTION: If the brushbar in the powered head has been obstructed, the
brushbar motor protection sensor may have been activated. The brushbar will
stop, the light on the powered head will illuminate red and the machine may
switch off. To reset remove the powered head from the reach wand/handheld
and clear any obstruction. Wait 1 minute before refitting the powered head
tool, switch the machine on and press the brushbar ON/OFF button.
IMPORTANT: The powered head brushbar should be ON for carpets and OFF for hard floors.
Constant use of the boost mode and brushbar will reduce the battery run time.
When the machine is in use the
battery level indicator lights will
illuminate indicating how much
charge is remaining. When less than
20% charge is remaining the bottom
light will flash red indicating the
battery is running low and charging
is required.
All of the accessories, including the
powered head can be attached
directly onto the handheld or the
reach wand. The crevice tool and
dusting brush can be used for hard
to reach places and at different
heights for above floor cleaning.
Using the cordless vacuum and tools
To Next Page
Loading...
Need help?
General
