12
If a minor problem develops, it usually can be remedied quite easily when the cause is identified by using
the check list below.
Troubleshooting
WARNING TO REDUCE THE RISK OF PERSONAL INJURY–UNPLUG BEFORE CLEANING OR
SERVICING.
Problem Possible Cause Possible Solution
Vacuum won’t run 1. Power cord not firmly
plugged in.
1. Plug unit in firmly.
2. No voltage in wall plug. 2. Check fuse or breaker in building.
3. Blown fuse or tripped
breaker.
2. Replace fuse/reset breaker in building.
4. Thermal Protector Activated 3. Allow cleaner to cool per instructions on
page 5.
Vacuum suction low 1. Bag full. 1. Empty bag.
2. Obstruction in nozzle. 2. Remove obstruction.
3. Secondary filter dirty. 3. Clean filter.
Nozzle won't pick up 1. Nozzle brush worn. 1. Replace brush
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors,
or dropped into water, take it to a service center prior to continuing use.
To Next Page
Loading...
Need help?
General
