ON-OFFPEDAL(Rg. 3,A)
1. To turn cleaner ON, step on pedal.
2. To turn cleaner OFF, step on pedal agian.
HANDLERELEASEPEDAL(Rgt3,B)
1. Grasp handle.
2. Step on Handle Release Pedal to release lower
handle to operating position.
3. Do not release grip on handle until handle is
returned into locked upright position
TRANSPORTING
1. To move your cleaner from room to room, put
handle in upright and locked position.
2. Tilt cleaner back on wheels and push forward
(Fig. 14).
CARRYHANDLES
The carpet washer may also be lifted by any of
several carry handles as shown. Be sure tanks are
properly latched in place before attempting to lift
(Fig 15).
A. Upper Handle
B. Solution Tank Handle
C. Dirty Water Tank Handle
D. Solution Tank Shelf
CLEANWATER/SOLUTIONTANK
The Clean Water / Solution Tank (Fig. t 6) is divided
into two sections. The Clean Water Tank (E) is for
water only and the Solution Tank (F) is for
cleaning solution only.
NOTE: Tanks are labeled above tank caps.
How toFill
1. Turn off and unplug cleaner from electrical
outlet.
2. To remove tank, press down on Solution Tank
Latch and pull forward. (Fig. t 7).
3. Fill Clean Water Tank (Fig. 18) with hot tap
water. The use of hot water as opposed to cold,
significantly improves cleaning performance.
B
)
NOTE: There may
be a small amount of
water on the base when
the tank is removed
from the unit. This is a
normal condition.
4. Fill Solution Tank (Fig. 19) with Hoover ®
Clean Plus 2X Solution or any other Hoover
solution (see "Cleaning Solutions" page 19
for details). Replace container caps and tighten.
5. Place Solution/Water Tank back on to the unit
using the method described on page 6.
Actual model may vary from images shown. 8
To Next Page
Loading...
