Hoover Telios Extra - Getting to Know Your Cleaner; Assembling Your Cleaner; Using Your Cleaner; Floor Type Selection

2
GETTING TO KNOW YOUR CLEANER
A. Accessory Door
B. Main Cleaner
C. Bag Door
D. Mechanical Bag Check Indicator*
E. On/Off Pedal
F. Exhaust Filter Cover
G. Cord Reel Pedal
H. Variable Power Control Slider**
H1. LED Display Screen with Variable Power Controls** and Led Bag Check Indicator*
I. Carry Handle
J. Bag Door Release Latch
K. Hose
L. Hose Handle**
M. Suction Regulator*
N. Telescopic Tube**
N
a. Telescopic Tube Latch*
N
b. Telescopic Tube Adjuster**
O. Carpet and Floor Nozzle (GP)**
O1. Carpet Nozzle (CA)*
O2. Hard Floor Nozzle (HF)*
P. Floor Type Selector Pedal*
Q. Carpet and Floor Nozzle Latch*
Ra. Pre-Motor Filter
Rb. Pre-Motor Filter Frame
S. Exhaust Filter
T. Bag Holder
U. Bag
V. Accessory Set
V1. Crevice Tool
V2. Furniture Nozzle
V3. Dusting Brush
W. Pet Hair Remover Mini Turbo Nozzle*
X. Allergen Remover Mini Turbo Nozzle*
Y. Parquet Nozzle*
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position.
To release the hose: Simply press the two latches on the hose end and pull. [1]
2. Connect the hose handle to the upper tube end. [2]
3. Connect the tube lower end to the carpet and oor nozzle** or accessories if required. [3]
USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker. [6]
2. Adjust the telescopic tube to the desired height by moving the telescopic tube adjuster**
and raise or lower the tube to the most comfortable cleaning position. [5]
3. After connecting the telescopic tube lower end to Carpet and Floor Nozzle** or
accessories if required, press the oor type selector* pedal on the nozzle to select
the ideal cleaning mode for the oor type.
[4]
Hard Floor – Brushes are lowered to protect the oor.
Carpet – Brushes are raised for deeper cleaning.
4. Switch the cleaner on by pressing the On/Off Pedal on the cleaner main body. [7]
5.
Adjust the power level by pressing the variable power control buttons on the
display** [8] or by adjusting the variable power control slider**. [9]
6. Adjust the suction regulator* to the desired level. [10]
7. Switch off at the end of use by pressing the On/Off Pedal. Unplug and extract power
cord again to wind the power cord back into the cleaner.
8. Parking and Storage - The tube can be parked for temporary storage while in use, or
in the storage position when not in use.
[11]
ACCESSORIES
To obtain the best performance and efciency it is recommended that the correct nozzles
are used for the main cleaning operations. These nozzles are indicated in the diagrams
by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard oor.
A nozzle type HF is suitable for use only on hard oor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
The Crevice tool, Furniture nozzle and Dusting brush are stored on board under
the accessories door.
All accessories can be tted to the end of the handle or the end of the telescopic
tube.
Accessory Set :
Crevice Tool –
For corners and hard to reach areas. [V1]
Furniture Nozzle – For soft furniture and fabrics. [V2]
*Certain Models Only ** May vary according to model