Check agitator brush roll
When agitator brush roll brushes are
worn, the agitator brush roll should be
replaced.
Tocheck condition of brushes, turn
cleanerOFF and disconnectfrom elec-
trical outlet.
©
What to buy
When purchasing a new agitator })rush
roll, ask for HOOVER part no.
48414140.
How to replace
Turn cleaner ON and rotate mode con-
trol dial to HARD FLOOR. Turn cleaner
OFF and disconnect from electrical out-
let. Place handle in upright position and
turn cleaner over so bottom side is up.
Q emove the five screws as shown
with a Phillips screwdriver. Lift off
bottom plate (A).
Q Move edge of a card acrossbot-
tom plate while turning agitator
})rushroll. To maintain cleaning effec-
tiveness, replace agitator })rushroll if
})rushesdo not touch card.
Pull up on agitator brush roll (C)
to remove from })rushroll cavity.
_Ii olding agitator })rushroll with
one hand, slide belt (D) off the
agitator })rushroll.
NOTE: Hold on to the belt with one
hand. Do not allow the belt to fall back
into the cavity on bottom of (leaner.
Q old new agitator })rushroll in
one hand; the belt in the other.
Slide the belt onto the agitator })rush
roll, positioning the belt in the belt guide
(E)on the agitator })rushroll.
(Cont'd) --* 1 3
To Next Page
Loading...
