O Align new filter bag collar (B)
,withtray (C). Slide bag collar all
the way into tray. The bag collar open-
ing will be sealedto the dirt tube open-
ing.
Tuck in filter bag inside the bag cavity.
Close bag door.
O isconnect cleanerfrom electricaloutlet. Do not use
cleanerwithout secondaryor final filter in place.
The secondary filter, located within the grill (A) in the bottom
of the bag compartment, protects the motor from dirt particles.
If filter becomes dirty, slide grill out and remove filter. Hand
wash filter with mild detergent and cold water. Rinse and let
filter air dry completely before repositioning in grill.
Align grill on tracks and slide in until it snaps into position.
Should you want to replace this filter, ask for HOOVER part
No. 38765031.
Headlight replacement
What to buy
This cleaner uses a T3 1/4 wedge
base bulb, HOOVER part no.
27313107.
Disconnect cleaner from electrical out-
let.
Presson handle release pedal and
lower the nozzle so it is flat. Remove
bag door (Fig. 32).
Remove lens
Q sing a Phillips screwdriver,
remove the three screws as
shown and lift off lens.
Pull old bulb straight out of socket.
Replace lens
O ush new bulb straight into
socket until locked in place. Do
not twist bulb.
Excessive force is not required.
Reposition lens and secure with the
three screws.
12
To Next Page
Loading...
