27
09.2006 TR20A002-A RE
Note:
If both keys are released before the end of the above-mentioned 4
seconds, the recoding or resetting process is terminated, in connection
with which three brief signal tones sound. The existing radio code is then
retained.
5.3 Direct function of the "bell/light" key
During normal operation the "bell/light" key has a special status – it can be
used directly just like a hand transmitter for transmitting and learning, i.e.
without having to enter an access code. Furthermore, its radio code can
be recoded as well as reset to the factory coding.
Within the operating functions this direct function is nearly always active, i.e.
even when an access code is being entered, provided no other key is
being pressed or in another radio code location no transmission, learning re-
coding or factory coding is taking place.
An exception is the phase of 20 seconds in which the same radio code can
be repeatedly transmitted, without a new access code having to be entered,
as in doing so the "bell"light" key for prematurely terminating this phase is re-
quired. During these 20 seconds the direct function of the "bell/light" key is
therefore deactivated.
5.3.1 Transmitting using the "bell/light" key
1. Press the "bell/light" key ➜ a long signal tone sounds and the radio code
belonging to it is transmitted (in doing so, rapid signal tones sound).
Note:
As long as the "bell/light" key continues to be pressed, the radio code is
transmitted, but for a maximum of 15 seconds.
To Next Page
Loading...