Hörmann FCT 10 - Learning using the bell;light key; Recoding the radio code location of the bell;light key or resetting this radio code location to the factory coding

28
09.2006 TR20A002-A RE
5.3.2 Learning using the "bell/light" key
Attention!
During the learning process, a door cycle can be initiated by activating
the teaching transmitter, provided a receiver programmed for it is located
nearby!
1. Hold the teaching transmitter as shown to the FCT 10 and then press and
keep pressed the desired key of which the radio code is to be learned
(see figure 5).
2. Press the "bell/light" key and keep it pressed ➜ if a valid entry has been
made, a long signal tone sounds.
3. If the received signal from the teaching transmitter is strong enough, after
approx. 0.5 seconds brief signal tones are emitted for about 4 seconds
indicating that the signal can be learned.
4. Keep the keys pressed right up until the end of these 4 seconds ➜ after
successfully entering the access code, a long signal tone sounds.
5. Release the keys of the teaching transmitter and of the FCT 10.
6. Carry out a function test, if this is unsuccessful, repeat the operation.
Note:
If the "bell/light" switch is released before the 4 seconds mentioned
above have elapsed, the learning process is aborted, signalled by three
brief signal tones. The existing radio code is then retained.
5.3.3 Recoding the radio code location of the "bell/light" key or
resetting this radio code location to the factory coding
1. Press the "bell/light" key and keep it pressed ➜ a long signal tone sounds.
2. Immediately afterwards press the "key" switch in addition and keep it
pressed ➜ brief signal tones start to be emitted for approx. 4 seconds
indicating that it is possible to recode or to reset to the factory coding.