29
09.2006 TR20A002-A RE
• If one of the two keys is released before the end of these 4
seconds, the existing radio code is then overwritten by a new
unique radio code ➜ after successfully recoding, a long signal
tone sounds.
• If the two keys continue to be pressed right up until the end
of the 4 seconds, the existing radio code is reset to the factory
coding ➜ after successfully resetting to the factory setting, a long
signal tone sounds.
3. Release the keys.
Note:
If the two keys are released before the end of the 4 seconds mentioned
above, the recoding or resetting process is terminated and three brief
signal tones sound. the existing radio code is then retained.
6 EU Manufacturer's Declaration
Manufacturer: Verkaufsgesellschaft KG
Upheider Weg 94 – 98
D-33803 Steinhagen
Product: Code modulator
Unit type: FCT 10
On the basis of its design and type in the version marketed by us the product
described above meets the relevant basic requirements of the directives lis-
ted below. In the event that the product is changed or modified without our
approval, this declaration loses its validity.
To Next Page
Loading...