To Next PageTo Next Page
Need help?Do you have a question about the Hörmann Liftronic 500 and is the answer not in the manual?
General| Motor | DC motor |
|---|---|
| Protection Category | IP20 |
| Radio Frequency | 868 MHz |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Remote Control | Yes |
| Lighting | Integrated LED light |
| Safety Features | Automatic safety cut-out |
| Power Supply | 230 V AC |
| Power Consumption Standby | Less than 1 W |
| Motor Type | DC |
| Control | Remote control |
| Drive Type | Chain |
| Max Door Height | Up to 2250 mm |
Lists documents required for safe use and maintenance.
Explains general warning symbols and their meanings.
Defines technical terms like DIL switches and impulse control.
Explains symbols used in the illustrated sections for clarity.
Specifies the intended use of the garage door operator.
Lists prohibited uses such as continuous or industrial operation.
Defines the qualifications required for installers and maintenance personnel.
General safety guidelines for all work on the door system.
Safety guidelines to be followed during the fitting process.
Safety precautions for the initial start-up and ongoing operation.
Safety guidelines for the proper use of the hand transmitter.
Details about safety-relevant control components and their approval.
Instructions for checking the door and its system before installation.
Specifies the minimum clearance needed between the door and ceiling.
Steps for preparing sectional doors for operator installation.
Steps for preparing up-and-over doors for operator installation.
Detailed steps for assembling and fitting the operator boom.
Instructions on how to mount the garage door operator itself.
Procedure to set the final open and close positions of the door.
Instructions for installing and checking the emergency release.
Guidance on where and how to attach the warning sign.
Overview of the operator's display and control elements.
Process for teaching the operator the door's travel parameters.
Guidance on connecting external components and accessories.
Explains the functions programmed via DIL switches.
Description of the RSC 2 hand transmitter and its controls.
Declaration of conformity excerpt for radio components.
Information about the integrated radio receiver's capabilities.
Step-by-step guide for programming hand transmitters.
Instructions for operating the operator via radio.
Procedure for clearing all stored radio codes.
Guidance on instructing users on safe operation.
Procedures for testing the operator's functions.
Describes the standard operating sequence and behavior.
How to operate the door during a power outage.
Steps to follow after power is restored.
Instructions for checking and adjusting the toothed belt tension.
Procedure to test the safety reversal function.
Instructions for replacing the operator light bulb.
Explains the meanings of the operator light's flashing patterns.
Explains the red LED signals for errors and warnings.
