7 8
Your tyres have been pumped to 30 psi/2bar. Give them a
squeeze; there should be very little give. They have Schrader
valves (like your car tyres). Check them regularly as low
pressure tyres are harder to pedal!
Pedals
Insert pedals by hand taking care not to cross thread, then use a 15mm
spanner or adjustable wrench.
a. Identify L (left) and R (right) stamped on the end of the pedal bolt as they
have different threads.
Rear Front
Reset the brakes by squeezing the two sides together and engaging the cable tube
back into its housing. Push the rubber boot back (Fig 2 followed by Fig 1 - p6).
Check that the wheel can spin freely.
Undo the axle using a 5mm Allen key so that it is wide enough
fit in the dropouts at the bottom of the front forks.
Tighten both sides (10-12Nm).
b. It’s a good idea to add some grease or oil to the threads.
c. Fit the right pedal (drive belt side) turning clockwise.
d. Fit the left pedal (non drive belt side) turning anticlockwise.
To Next Page
Loading...