11
5
Installation
5.1 Check before installing
Check before installing whether there is enough space to install the
product, the UCS does not block any other products after installing,
and if the wall thickness is enough for the screws supplied.
For safety reason, please pay attention to any wiring and electrical
components in the installation area. Pay close attention to wiring
out of sight while drilling/fastening screws.
5.2 Customization (pag. 17 (A) t/m pag. 22 (L))
It is possible to change the dimensions of the product into the
desired window size. For this, measure the height and width of the
window hole.
A: If the window has a rubber frame (RK), measure the outside of
the rubber.
B: If the window has a aluminum frame (AK), measure the actual
hole in the vehicle wall.
The table below shows which formulas must be adhered to for
tailoring the product.
Type
window
Cutting width (mm) Cutting height (mm)
RK Width rubber frame + 2 Height rubber frame - 43
AK Width window hole Height window hole - 45
To Next Page
Loading...
