Why am I getting too many double seeds with horsch Farm Equipment?
If you're getting too many double seeds with your Horsch Farm Equipment, the scraper might not be adjusted correctly. Try adjusting the scraper more aggressively. Alternatively, the vacuum might be set too high; in that case, reduce the vacuum.
What to do if horsch Maestro 12 SW Seeders show too many faults?
If your horsch Seeders are experiencing too many faults, it could be due to several factors. First, the working speed might be too high, so reducing it could help. Second, the scraper might not be correctly adjusted; try adjusting it less aggressively. Third, the vacuum might be set too low, so increasing it could resolve the issue. Lastly, the gap between the metering disc and metering housing might be too big, requiring you to remove a shim.
Why is horsch Seeders not placing enough fertiliser?
If the horsch Seeders are not placing enough fertiliser, first repeat the calibration to ensure it is correct. Next, check for seed bridging in the hopper and use free-flowing fertiliser to prevent this. Also, inspect the metering cells to ensure they are not stuck together; if they are, clean them.
Why is horsch Maestro 12 SW Seeders placing too much fertiliser?
If the horsch Seeders are placing too much fertiliser, the calibration may not be correct, so repeat the calibration. Also, the sealing lip may be defective or incorrectly adjusted, so check or replace the sealing lip.
How to fix one row not drilling on horsch Seeders?
If one row of your horsch Seeders is not drilling, it could be due to a few reasons. There might be foreign objects in the seed hopper or metering unit, so clean them. Alternatively, the vacuum connection may be interrupted, so check the vacuum connection and hose. Lastly, the motor could be defective, requiring replacement.
Why are there too many double seeds with horsch Maestro 12 SW Seeders?
If you're seeing too many double seeds from your horsch Seeders, the scraper might not be correctly adjusted; try adjusting it more aggressively. Alternatively, the vacuum might be set too high, so reduce the vacuum.
Why does the drill unit stop on my horsch Farm Equipment?
If the drill unit on your Horsch Farm Equipment stops, it could be due to a foreign object in the metering unit. Clean the metering unit to resolve this issue.
How to prevent downpipes from clogging on horsch Farm Equipment?
To prevent downpipes or drill discs from clogging on your Horsch Farm Equipment, only move the drill forward when it is lowered.
What to do if seed grains are scattered by horsch Farm Equipment?
If seed grains are being scattered by your Horsch Farm Equipment, ensure that your working speed matches the conditions. Also, inspect the downpipe for correct assembly, blockages, or defects; correct the assembly or replace the downpipe if necessary. Adjust the trap roller to coulter height or 5 mm lower. If the trap roller is defective or hard to move, replace it.
Why is current consumption too high on horsch Maestro 12 SW?
If the current consumption is too high on your horsch Seeders, the gap between the metering disc and metering housing might be too small. Insert a shim to correct this.
To Next Page
General
