EasyManua.ls Logo

horsch Pronto 8 SW - User Manual

horsch Pronto 8 SW
76 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
TRANSLATION OF THE ORIGINAL OPERATING INSTRUCTIONS
READ CAREFULLY PRIOR TO STARTING UP!
KEEP OPERATING INSTRUCTIONS IN A SAFE PLACE!
ART.:
ISSUE:
OPERATING INSTRUCTIONS
02
05
07/2017
8020
Pronto 8 / 9 SW

Table of Contents

Questions and Answers

  • A
    Angela MurrayAug 9, 2025
    Why is the placing quantity too low on my horsch Pronto 8 SW Seeders?
    • S
      Sara StantonAug 10, 2025
      There are several potential reasons for a low placing quantity: * A worn sealing lip in the metering unit. If this is the case, replace the sealing lip. * The placing quantity might be set too low. You should check the adjustment on the terminal and correct it as needed. * A leak in the pressurized hopper of the seed wagon. Inspect the hopper for leaks and replace the seals if necessary. * A leak in the pneumatic system. Examine the distributor and all pneumatic hoses for leaks, replacing any faulty components.
  • N
    Nicholas RobinsonAug 26, 2025
    What to do if horsch Pronto 8 SW sporadically skips work signal?
    • E
      ecrawfordAug 27, 2025
      Sporadic skipping of the work signal may occur if the control unit on the tractor is set incorrectly. To resolve this, switch the control units on the tractor to the correct position; refer to the 'Field work' section for guidance.

horsch Pronto 8 SW Specifications

General IconGeneral
Brandhorsch
ModelPronto 8 SW
CategorySeeders
LanguageEnglish

Related product manuals