Electronic 7
User Operating Instructions
The Horstmann Electronic 7 Water Heater Controller has been especially
developed to control the immersion heater as economically and conveniently
as possible.
During the night, water in the tank will be heated by cheap night-rate
electricity, ensuring a tank of hot water is available for the morning.
Depending on the size of the tank and usage of hot water, this will usually last
a day; however, if required, more hot water can be heated at any time by using
the ‘boost’ button which switches on the immersion heater for one hour.
Alternatively if it is known that extra hot water will be required every day, the
‘boost’ element (in the tank) can be programmed so that it will heat only a
small part of your tank. This is normally the upper element in the tank and can
be programmed to come on once each day at a set time.
Some tariffs offer additional cheaper electricity periods during the day time;
the Electronic 7 has extra off peak switching periods available to
accommodate this.
1
To Next Page
Need help?
General
