Place the mower clockwise on the boundary wire in front of the charging station in order to
start configuring the functional settings.
Press "MENU" to set the functions. The screen offers you different selection options, AREA
, MODE , CHANGE PIN CODE , TIME & DATE , LANGUAGE and
SETTINGS .
2. FUNCTIONAL SETTINGS
• Press "HOME" to direct the mower back to the charge station (this is to stop the mower
during mowing): Press “HOME”, the mower will stop mowing, find the closest fence line, then
go back to the charging station along the line. In this condition, after fully charged, mower
won’t start by itself, have to re-start by manual.
Set the Language
•Select to set the indicating languages, press "OK", then select one of the following
choices, press "OK" again.
Set the PIN CODE
•Select to set 4 numbers start password, screens as below:
1) Enter pin code: input initial password “0000”.
2) Enter new pin code: to input new password.
3) Confirm new pin: to input new password again.
4) When it shows PIN accepted, it means new password has been accepted, and will return
automatically.
5) In case the password was input incorrectly, the screen will show: PIN not accepted. Press
"OK" to return the upper menu.
To Next Page
Loading...
Need help?
General