Need help?Do you have a question about the Hoshizaki AM-50BAE and is the answer not in the manual?
General| Storage Bin Capacity | 22 lbs |
|---|---|
| Voltage | 115V |
| Condenser | Air-Cooled |
| Frequency | 60 Hz |
| Ice Production Capacity | 55 lbs per 24 hours |
| Amperage | 3.8 A |
| Refrigerant | R-134a |
Details physical dimensions and connection points for both models.
Lists technical specifications for AM-50BAE and AM-50BAE-AD models.
Outlines the external components and build of the icemaker unit.
Details the internal components involved in the ice-making process.
Crucial checks to perform before installing the icemaker unit.
Guidelines for selecting an optimal and safe location for the icemaker.
Covers initial setup, built-in procedures, and site checks.
Step-by-step guide to reverse the door hinges for flexible placement.
Procedures for safely connecting the icemaker to the power supply.
Instructions for connecting water supply and drain lines correctly.
A comprehensive checklist to ensure all installations are correct before operation.
Procedures to follow for the initial startup of the icemaker.
Steps to properly prepare the icemaker for extended periods of non-use.
Detailed steps for cleaning and sanitizing the icemaker and its components.
Routine maintenance tasks for the icemaker's exterior and condenser.
Instructions for inspecting and maintaining the water valve assembly.
Diagrams illustrating the water and refrigerant flow within the icemaker.
Schematic diagram showing the electrical connections and components.
Explains icemaking and defrost control logic.
Procedures for checking the electronic controller and thermistor.
Guidance on adjusting electronic controls after component replacement.
Visual representation of the icemaker's operational cycles over time.
Data tables detailing performance metrics for different operating conditions.
A guide to identify and resolve common problems with the icemaker.
Information and precautions for servicing the refrigerant lines and related components.
Covers refrigerant recovery, evacuation, and recharging procedures.
Detailed steps for removing and replacing the compressor unit.
Procedure for replacing the refrigerant drier component.
Instructions for removing and installing a new evaporator.
Steps for replacing the hot gas valve.
Procedure for replacing the pump motor.
Steps for removing and installing a new fan motor.
Instructions for replacing the water valve.
Procedure for replacing the electronic controller board.
Steps for replacing the thermistor for cube control.
Procedure for replacing the bin control thermostat.
To Next Page
