What to do if my Hoshizaki Ice Maker is not producing ice?
If your Hoshizaki Ice Maker isn't producing any ice, there are several potential causes. First, ensure the unit is properly plugged in and that there isn't a power failure. Check that the Power Switch (Earth Leakage Circuit Breaker) is turned ON. If the display is flashing error codes "C1" or "E1" - "EC", refer to the troubleshooting guide for those specific error codes.
What to do if Hoshizaki Ice Maker is leaking water?
If your Hoshizaki Ice Maker is leaking water, check the Drain Pipe and Trap for any clogs and clear them. Ensure the Drain Pipe isn't bent or crushed; straighten it if it is. Verify that the Drain Pipe is positioned lower than the drain outlet and that it's properly connected to the sewer system.
Why is my Hoshizaki Ice Maker producing ice slowly?
If your Hoshizaki Ice Maker's ice production is slow, it could be due to several factors. The ambient temperature might be too high (exceeding 35°C), in which case you should try to reduce the room temperature. An external heat source could be affecting the unit; remove any such sources. Make sure that the airflow isn't blocked by anything in front of the Front Cover and ensure the Air Filter is clean; if not, clean or replace it.
Why Hoshizaki IM-30M incomplete ice production with large dimple?
If you're experiencing incomplete ice production with a large dimple in your Hoshizaki Ice Maker, there are several possible causes. Check for a power failure and restore power if necessary. Avoid turning the Power Switch off and on during operation, and also avoid pressing the Reset Button during operation. Ensure that the water supply pressure is adequate; increase it if it's too low. High ambient temperatures (exceeding 35°C) can also cause this issue, so reduce the ambient temperature. Additionally, external heat sources or blocked airflow due to objects in front of the Front Cover can contribute to the problem. Finally, a dirty Air Filter can also be a factor, so clean or replace it.
How to fix insufficient icemaking water in Hoshizaki Ice Maker?
If your Hoshizaki Ice Maker isn't getting enough water, start by checking the water supply to ensure it's functioning correctly. Make sure the Water Supply Valve is open. Also, verify that the water pressure is sufficient and increase it if it is too low.
Why is the ice from my Hoshizaki IM-30M cloudy?
If the ice from your Hoshizaki Ice Maker is cloudy, the issue might be related to water quality. You should test and improve the water quality.
To Next Page
General