Need help?Do you have a question about the Hoshizaki KM-515MAH-E and is the answer not in the manual?
Main component of the ice cuber assembly.
The structural base of the ice cuber.
The internal frame structure.
The frame at the top of the unit.
The side structural frames.
Insulation material for the top panel.
Insulation material for the front panel.
Right side panel of the unit.
Air filter component.
Louver component.
Barrier component.
Flexible silicone hose.
Sealing gasket.
Insulation barrier.
Ring for capillary tube.
Electrical transformer component.
Cover for the transformer.
Bushing component.
Power cord for the unit.
Fastening cable tie.
Mount for cable tie.
Component responsible for heat dissipation.
Protective shroud for components.
Barrier component.
Component for cooling.
The heart of the refrigeration system.
Protective cover or guard.
Valve body for the liquid line.
Bracket for the fan motor.
Motor driving the fan.
Blade attached to the fan motor.
Component to remove moisture from refrigerant.
Controls refrigerant flow.
Valve body for the hot gas line.
Valve coil component.
Switch monitoring pressure.
Sealing gasket.
Valve for accessing copper tube.
General access valve.
High-pressure side copper tube.
Another high-pressure side copper tube.
Another high-pressure side copper tube.
Another high-pressure side copper tube.
Another high-pressure side copper tube.
Component for heat transfer.
Elbow fitting.
Copper tube for hot gas.
Holder for expansion valve.
Clamping component.
Cover for expansion valve.
Temperature sensing component.
Holder for thermistor.
Insulation for thermistor.
Insulation for thermistor.
Rubber insulation material.
Another rubber insulation.
Holder for insulation.
Various lengths of insulation tubes.
Saddle for routing wires.
Cable tie for bundling.
Bracket for line valve.
Assembly for the water pump motor.
Flexible rubber hose for water.
Pipe carrying water supply.
Rubber gasket for sealing.
Bracket for the water valve.
Valve controlling water flow.
Tube for spraying water.
Guide for the spray tube.
Guide for ice cubes.
Hose for suction.
Bracket for the pump motor.
Housing for the drain valve.
Spring component.
Seat for the valve.
Hose for draining.
Cap for overflow.
Pipe for overflow.
Connector for float switch.
Switch for water level detection.
Vinyl hose.
Bushing component.
Silicone hose.
Insulation material.
Another silicone hose.
Another vinyl hose.
Tube for water supply.
Plug component.
Various hose clamps.
Coupling for insertion.
Pipe for connection.
The main enclosure for control components.
Running capacitor for motor.
Starting capacitor for motor.
Strap for securing components.
Component for starting motors.
Electrical switch controlled by a coil.
Spare fuse for protection.
Electrical transformer.
Capacitor for the pump motor.
The main circuit board.
Support for the control board.
Bushing components.
Clamping component.
Capacitor for the fan motor.
Brand emblem.
Label indicating alarm.
Penguin logo label.
Label for air filter.
Label for maintenance information.
Warning label.
Label for wiring.
Grounding label.
Unit identification nameplate.
Label for instruction sheet.
Label for manual.
Label indicating refrigerant type.
Label with instructions.
Another caution label.
Label for control board.
Label for fuse.
Label for water supply.
The main front panel of the unit.
Insulation material for the panel.
Additional front insulation.
Foam seals for the front panel.
The main top panel of the unit.
Gasket for the top panel.
Insulation for the top panel.
Foam seal for the top panel.
The motor driving the pump.
Seal for the mechanical pump.
Flange for the pump.
Gasket for the pump.
Rotating component of the pump.
Pin for securing parts.
Enclosure for the pump impeller.
Housing for a plug.
Grounding tooth washer.
The control box enclosure.
User-operated toggle switch.
Label for control panel.
Temperature control component.
Holder for the fuse.
Electrical protection device.
Manual for operation and maintenance.
Manual for unit installation.
Universal bracing component.
Standard bolt.
Packaging materials for the unit.
To Next Page
General