Hoss Double Wheel Hoe - Mounting Cultivator Teeth; Procedure and Attachments

3
1.888.672.5536
Mounting Cultivator Teeth to the Toolbar
Materials Required:
4 – Cultivator Teeth
4 – 3/8” x 2” Carriage Head Bolts with 4 Flanged Nuts
1) Place 3/8” x 2” Carriage Head Bolt from bottom up through the front hole of Cultivator Teeth and
into the toolbar.
2) Adjust to the desired position and secure using a 3/8” flanged nut and 9/16” wrench.
See all of our other Wheel Hoe Attachments at www.hosstools.com
Oscillating
Hoes
Sweeps
Plows
Disk Harrow