Need help?Do you have a question about the Hot Bodies CYCLONE and is the answer not in the manual?
Specifies locations where driving is prohibited to prevent accidents and damage.
Attaches initial chassis components including bulkheads, motor mount, and suspension parts.
Assembles the differential housing using gears, bearings, and shafts.
Completes the differential assembly by attaching cup joints and drive rings.
Assembles the differential gears and related components using parts from bags B and C.
Provides crucial instructions on tightening differentials for proper function and to prevent damage.
Installs gears, pulleys, and drive shafts to form the drivetrain.
Routes and installs drive belts for the transmission system.
Assembles the front suspension arms and associated components.
Assembles the rear suspension arms and associated components.
Sets the initial front droop to 7mm using the Z724 set screw.
Sets the initial rear droop to 6mm using the Z724 set screw.
Assembles the shock absorbers, including oiling O-rings and screwing ball ends.
Assembles shock absorber components and includes tips for removing air.
Adjusts motor screws to ensure smooth gear meshing and proper backlash.
Records front suspension settings including camber angle, castor, and ride height.
Records rear suspension settings such as camber, ride height, and droop.
Details shock settings like piston size, hole count, oil weight, springs, and bladder.
General| Type | Touring Car |
|---|---|
| Motor | 540 |
| Suspension | Four-wheel independent |
| Tire Type | Rubber |
| Body Material | Polycarbonate |
| Scale | 1:10 |
To Next Page
